An AC vacuum pull is necessary to remove any air and moisture that remains in the system. It is especially useful before testing, repairing, and recharging the air conditioner. Despite the fact that a professional can perform vacuum pulling efficiently, it does not harm to learn how to use an AC vacuum pump yourself if you like.
Steps For Using An AC Vacuum Pump
You must have some experience handling your car before continuing with the steps. Otherwise, you could end up damaging the AC system of your car. You know the ins and outs of your car, don’t you? Below are the steps to take.
Step 1. Set Up The Vacuum Pump
Preparing the vacuum is the first step in using an AC vacuum pump. First, get your vacuum pump and oil. Look for the cap-like sign on the top of the pump to locate the vacuum oil cap. Remove the cap and fill it with oil until it reaches the recommended level. It is always better to use good quality vacuum oil instead of any other oil.
Step 2. Get The Gauges And Ports In Order
Gauge sets are used to connect the vacuum and pressure ports on AC systems. Blue gauges in these sets need to be connected to the low-pressure ports.
The red, high-pressure gauge will go to your vacuum port, and the yellow, high-pressure gauge would go right to your high-pressure port. Be sure all the connections are tight and there are no loose connections.
Step 3. Begin The Vacuum Function
When everything’s connected, it’s time to turn the vacuum on. A vacuum device has a switch on it, and you flip it to turn it on. You’ll see the light or hear a sound when the vacuum is ready to go.
For any confusion, you should always check the manual. Open the side gauge valves on both sides. This causes the device to perform the sucking action that removes humidity and air from the air conditioner.
Step 4. Keep The Vacuum Running
It takes from 15 to 30 minutes to draw out moisture and air. Be sure to operate your device at full speed and read the manufacturer’s instructions as well. You can determine how long your AC and vacuum pump should be used to clean your HVAC system.
Step 5. The End of the Process
The low-side valve can be turned off after the vacuum has run for a while. The pump can hold a vacuum for 15 minutes by turning off the valve that connects to the low-side gauge.
The components of the pump likely leak if the hold does not last for 15 minutes sometimes. Changing the components might be the right solution.
It is time to turn off the pump by turning off the switch you used to turn on the pump once you have operated using the vacuum for the recommended amount of time. Once the vacuum is disengaged, disconnect the vacuum from the AC and remove all the hoses.
The AC system should be completely evacuated, meaning that no air or moisture should remain in the system at all. The AC is ready for operation after it has been repaired or replaced, and you can now set it up.
The Consequences Of Not Vacuuming Your Air Conditioner System
It is necessary to have refrigerant in an AC system for the cabin to receive cold air and stay cool. Therefore, it is necessary to refill the refrigerant periodically. The air or moisture from the container will be removed during the AC vacuum process before we fill it with water.
As a result, it is very important to remove the air because the presence of any of these contents directly affects the quality of the AC system. Moreover, as a result of the present moisture, the AC could have trouble operating, and also, the situation might worsen if it has to pass the cool air. A vacuum not only helps remove everyday dust and dirt from the air conditioner, but it also serves to remove the dirty air after a long day.
Conclusion
Hopefully, you have now understood why it is necessary to vacuum the AC and how to use a vacuum pump to accomplish the task. It is important to use the correct kind of oil and a quality AC vacuum that will not blow away when you are doing this. Whenever in doubt, you should take your automobile to a professional auto repair shop and let them do the work hassle-free.
